How to shut off your water main in an emergency
Knowing where your main water shutoff is, and that it turns, is the single most useful thing you can know before a pipe bursts. Find it now, not during the emergency.

Water from a burst pipe does not stop on its own. It stops when someone closes the main shutoff valve, and every minute before that happens is water on the floor. This guide shows you where the shutoff is in a typical Cleveland home, how to turn it, and what to do if it will not move. Read it now, find your valve today, and the emergency version of this job takes seconds instead of a panicked search.
Where the main shutoff is
Most Cleveland homes have two places to stop the water. The first is the shutoff at the house itself, usually where the main line enters the home, often in the garage, a utility closet, or near the water heater. It may be a lever handle that turns a quarter-turn, or a round wheel handle that turns several times. The second is at the water meter, usually in a box in the ground near the street or at the edge of the yard, which has a shutoff on the house side of the meter. Learn both locations. The house valve is the one you will reach first in an emergency, and the meter valve is the backup if the house valve fails.
How to turn it off
For a lever handle, turn it so it sits across the pipe, at a right angle to the direction of flow. For a wheel handle, turn it clockwise until it stops. Then open a faucet at the lowest point in the house to drain the lines, and open one at the highest point to let air in. If water keeps flowing after you close the valve, the valve itself may be worn and not sealing: close the meter valve as well. Once the water is off, call a plumber and describe what happened. Do not turn the water back on until the leak is fixed, because a burst line will simply start flowing again.
Whose line is whose
Generally, the homeowner's line runs from the meter to the house, and the city main and the meter itself belong to the water provider. The exact private-versus-city boundary for a given property in Cleveland has not been published in a form we can rely on, so confirm with the City for your property before you assume where your responsibility ends. What is not in doubt is that the shutoff at the house and the valve on the house side of the meter are yours to know and to use. If a leak is between the meter and the house, shut the water off and call a plumber; if the leak is at the meter or on the street side, call the water provider as well. Our main water line repair page covers the homeowner's side of the line, and our leak detection team can find a leak you can hear but cannot see.
If the valve will not turn
A shutoff valve that has not moved in years can seize, and forcing it can break the valve or the pipe behind it. If the handle will not move with firm hand pressure, stop and use the other valve instead: if the house valve is stuck, go to the meter. If both are stuck, call a plumber and, if water is flowing, call the water provider to shut the water off at the street. Do not use a wrench to force a seized valve in an emergency unless you are prepared for it to break. The right fix is to have the valve replaced before the next emergency, when there is time to do it properly. Test both valves twice a year, and label them so anyone in the house can find them.
After the water is off
Once the water is off, move rugs, electronics, and anything water will ruin, and take photos of the damage for your own records. Do not mop first and call second: call the plumber first, because the leak needs finding before the drying starts. If the burst was caused by a freeze, do not thaw the line with a torch or an open flame. If sewage is involved, keep clear of the water and do not run more water down the drains. Our emergency plumbing services in Cleveland, TX handle burst pipes during business hours, Monday through Saturday, 7:00 AM to 5:30 PM, and homeowners in Downtown Cleveland with older lines should know that a corroded shutoff is one of the most common surprises in an emergency.
Frequently Asked Questions
Where is the main water shutoff in a Cleveland TX home?
Usually where the main line enters the house, often in the garage, a utility closet, or near the water heater. There is also a shutoff at the water meter, usually in a box in the ground near the street. Learn both locations.
Which way do I turn the shutoff valve?
Turn a lever handle so it sits across the pipe, at a right angle to the flow. Turn a wheel handle clockwise until it stops. Then open a low faucet to drain the lines.
What if the shutoff valve will not turn?
Do not force it. Use the other valve, at the meter if the house valve is stuck, or at the house if the meter valve is stuck. If both are stuck, call a plumber and the water provider.
Is the line from the meter to the house mine or the city's?
Generally, the homeowner's line runs from the meter to the house, and the city main and meter belong to the water provider. Confirm with the City for your property before assuming where your responsibility ends.
What should I do after shutting off the water?
Move anything water will ruin, take photos of the damage, and call a plumber before you start mopping. Do not turn the water back on until the leak is fixed.
Get help with plumbing in Cleveland
If a pipe has burst in your Cleveland home and the water is off, call Precision Plumbing LLC at (346) 687-0011 during business hours, Monday through Saturday, 7:00 AM to 5:30 PM. We find the break, repair it, and test the line before we leave.




